Meshtastic · Web Serial

MeshProv. flash & configure a node

Pick your community, add your name and PIN, plug in, press one button. Settings go from this tab to the radio over USB and nowhere else.

Firmware: current beta, checked when you flash · tested with 2.7.26.54e0d8d

01Youalways required

Shown on the mesh. Skip contact details.
1–4 characters, unique per radio.
Write it down. You'll type it when pairing the phone app.

02Radio settings

    Source: · checked
    No published settings yet:

    03Hardware

    nRF52 boards (T-Echo, RAK4631): drag the UF2 onto the board's USB drive, then use "Configure only".

    04Go

    1. Settings
    2. Flash
    3. Configure
    4. Verify
    "Erase" means everything on the radio: nodes, messages, keys. When the browser asks, pick the port that appeared when you plugged in (CP210x, USB JTAG or usbmodem).